Step 1. - Cut Hole Into Counter For The Sink

- Place the kitchen sink upside down on the kitchen counter.

- Draw a line around the kitchen sink making sure the kitchen sink edge is parallel to the counter edge.

- Take off the kitchen sink and draw a cutting line that is half inch inside the kitchen sink outline you drew above.

- Dril a pilot hole at each corner of the cut line.

- Using the electric or manual jigsaw, cut the hole along the straight cut lines.

Step 2. - Install Kitchen Sink

- Before you install the sink please make sure you have drilled the hole in your sink for a pillar sink mixer. If your sink mixer is a wall type then you do not need to drill this hole.

Tip : Install the waste/drain into the kitchen sink before dropping it into the hole. This will be easier to do now. Make sure you apply silicon around the waste for a water tight seal.

Step 3. - Apply Silicone Along The Edges

- Apply a bead of silicone around the edge of the hole and the edge of the kitchen sink from the inside.

- Drop the kitchen sink in place and apply even pressure on all sides.

- Make sure there are no gaps inbetween the counter and kitchen sink.

Step 4. – Add Clips, Bottle Trap and Connect Drain Pipe.

- Attach clips from the bottom of the sink and evenly place them around the sink while the silicone is still wet.

- Tighten these clips until you see the sink is drawn down to the counter top. Do not over tighten the clips.

- Remove and wipe out any excess silicone that sips out.

- Now you can connect your bottle trap to the sink waste.

- You can than connect the bottle trap to the sewage drain an also attach the over flow.

- Wait 24 hours for everything to dry and then open the water to check for any leaks.